Cute Gingham Heart Bowl - Snap-in Hearts
por ftm.design en MakerWorld
A little gingham bowl with tiny red hearts that you press in by hand after printing. The cream body with the pink check prints on one plate, and the hearts print flat on a second plate in about 16 minutes (55 hearts, so you get 4 spares).
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalStandard Digital File License
Licencia estándar de archivos digitales: solo uso personal. No se permite compartir, revender ni subir el archivo a otros sitios, ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a ftm.design.
- Categoría
- Hogar
- Descargas
- 0
- Publicado
Sobre este modelo
A little gingham bowl with tiny red hearts that you press in by hand after printing. The cream body with the pink check prints on one plate, and the hearts print flat on a second plate in about 16 minutes (55 hearts, so you get 4 spares).
It's about 140 mm wide and 50 mm tall, takes around 2.5 hours and ~93 g, and needs no supports. Lovely for fruit, wrapped candy, keys or little trinkets on a shelf.
Snapping the hearts in: hold a heart point-down with the flat back toward the bowl, tuck the top edge into the top of the slot first, then press the bottom in. If one feels loose, a tiny drop of glue fixes it; if it's tight, sand the edge lightly. Heads up: there are 51 hearts, so putting them all in takes about 15 minutes. I found it a calm little task with some music on.
Decorative / dry food only: PLA isn't food-certified, so keep it for dry snacks, whole fruit or trinkets. No hot food, microwave or dishwasher.
Descripción original del autor, publicada en MakerWorld.
