Cute Dragon - more easy printing
por Sebastian Popp en Thingiverse
The original cute dragon is a nice modell, but quite hard to print. I made a few changes so it can be printed out of the box without trouble: .) Scaled it down a bit (it was too big for my purpose) .) Cut the feets a tiny little bit to get a flat surface so it can be printed. .) Add manual support..
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Sebastian Popp.
Archivos (1)
- Categoría
- Varios
- Formatos
- STL
- Descargas
- 275,980
- Publicado
Sobre este modelo
The original cute dragon is a nice modell, but quite hard to print. I made a few changes so it can be printed out of the box without trouble: .) Scaled it down a bit (it was too big for my purpose) .) Cut the feets a tiny little bit to get a flat surface so it can be printed. .) Add manual support in Meshmixer to make it printable without tons of support material and hughe cleanup.
Descripción original del autor, publicada en Thingiverse.
