Custom Electronics Enclosure Prototype for Reused Vape Components
Custom Electronics Enclosure Prototype for Reused Vape Components
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Revisa las condicionesCopyright (ro vox)
El autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a ro.qd.
Archivos (1)
- m31_vp_case.stl STL · 105 KB
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
Custom Electronics Enclosure Prototype for Reused Vape Components
An unfinished enclosure concept for reusing electronics, battery contacts and a connector assembly from an old vape device.
Need a custom part for your setup? I design print-ready models from photos, sketches and measurements. Request a custom design (https://roqd.one/ith)
I started this as an experiment in reusing working electronics from a damaged device instead of replacing the whole unit. The enclosure was designed around the existing board, display, battery contacts and upper connector, but the project was never fully finished.
Key details - Height: 85 mm - Width: 26.5 mm - Length: 33 mm
Files included - Prototype electronics enclosure model
Important
This is an unfinished prototype, not a validated product. Battery-powered and heating electronics can present fire, burn and electrical risks. Verify every component, clearance and connection before use.
Follow me: roqd.one (https://roqd.one/ith)
roqd/m31
Descripción original del autor, publicada en Thangs.
