Cup Can Holder desk clamp
por BigBoomPrints en Thangs
Here is Cup Can Holder desk clamp, This awesome design comes in two sizes, the normal size which fits a standard 355ml 2.6ich/ 6.7cm diameter can, the small size fits energy drink size cans 250ml 2.09ich/ 5.3cm diameter can. These two designs mount to your desk or table using the screw and clamp, To
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a BigBoomPrints.
Archivos (7)
- Cup Holder desk clamp small.stl STL · 197 KB
- Cup Holder desk clamp Normal.stl STL · 190 KB
- Cup Holder desk clamp.stl STL · 268 KB
- Cup Holder Screw.stl STL · 387 KB
- Cup Holder desk clamp XL 11.5cm low.stl STL · 106 KB
- Cup Holder desk clamp XL 11.5cm High.stl STL · 106 KB
- Cup Holder desk clamp XL 11.5cm Thick.stl STL · 103 KB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 728
- Publicado
Sobre este modelo
Here is Cup Can Holder desk clamp, This awesome design comes in two sizes, the normal size which fits a standard 355ml 2.6ich/ 6.7cm diameter can, the small size fits energy drink size cans 250ml 2.09ich/ 5.3cm diameter can. These two designs mount to your desk or table using the screw and clamp, To assemble the design simply print of all pieces then thread the screw into the holder, to place the clamp on the end of the screw you can use a heat gun to make it easier or slowly twist it back and forth until it clips into place, you want to take your time doing this as it needs to be tight to work well, You can also use a knife to make the hole slightly bigger. Print settings supports needed for the Holder, Support type normal, Support placement everywhere, Nozzle size 0.4mm, Layer height 0.2mm, Print speed 100mms, Infill 15%, Wall count 3.
Descripción original del autor, publicada en Thangs.
