CRYSTAL DRAGON
por Vlado Turek en Printables
In oldtime, when people couldn´t make spears yet and the nights were darker than your frightening imagination, Crystal…
Licencia
Solo uso personalCC BY-NC-ND 4.0 — Atribución, no comercial, sin derivadas
Solo para uso personal, sin modificarlo y dando crédito. No se permite vender ni redistribuir cambios.
Al descargar aceptas respetar la licencia y dar crédito a Vlado Turek.
Archivos (3)
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 5,281
- Publicado
Sobre este modelo
In oldtime, when people couldn´t make spears yet and the nights were darker than your frightening imagination, Crystal Dragons ruled the world. They flew without fear through the world. They loved magic crystals that gave them invincible power. Until ...
Print instructions The dragon bust was designed primarily for DLP/SLA printers. It was reduced to 50% of its size. I recommend to print it in a position like on the sreenshots of a slicer. You don´t have to put any supports under thorns. I recommend to make a hollow model and place holes in the correct positions. A little force is needed to set the jaw. Beware of its breaking. I printed it on my Anycubic Photon. I used a new Ameralabs AMD-3 Grey resin with these print parameters:
6 bottom layers
60 bottom exposure time (s)
0.03 layer thickness (mm)
4.4 normal exposure time (s)
Descripción original del autor, publicada en Printables.
