Crown Of Thorns Cross - Flat Bottom
por Printing Makes Me Happy en Printables
A simple, wall mountable cross with a crown of thorns around its center.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo sin pedir permiso ni dar crédito.
Al descargar aceptas respetar la licencia y dar crédito a Printing Makes Me Happy.
Archivos (1)
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
The original .STL file doesn't have a flat bottom, the intricate thorn design continues below the level of the cross, requiring extra supports. I fixed that "problem" for easier post-processing. The fourth and fifth pictures compare the backs and fronts of the two crosses, with my remix on the left and the original on the right. Suggested Print Settings: - Material: PLA
- Walls: 2
- Layer Height: 0.2 mm
- Infill: 15%
- Brim: Unnecessary (unless you scale it down)
- Supports: On (there is a small overhang at the bottom of the thorns)
Only ⁓1.5 hour print at 15% infill! Multicolor: Insert pause between the last layer of the cross and the rest of the thorns. Between layer 40 and 41 at 0.2 mm layer height. Post-Processing: Remove supports at base of thorns. Some stringing may occur at the top of the thorns. Just file it off. Has a nail hole for mounting or you can use a command strip.
Descripción original del autor, publicada en Printables.
