Creality CFS Spool Weight
por M P en Thingiverse
I have been finding that when a spool has less that 1/3 left it wobbles, turns sideways, errors out, and does not retract correctly in a CFS. Here is a container that is streamlined so that very little protrudes from the sides of the spool. There is a twistable flange ring to snug it up to the...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a M P.
Archivos (3)
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
I have been finding that when a spool has less that 1/3 left it wobbles, turns sideways, errors out, and does not retract correctly in a CFS. Here is a container that is streamlined so that very little protrudes from the sides of the spool. There is a twistable flange ring to snug it up to the spool. It has a plug on one end to fill it with your weight of choice. There are baffles on the inside to stop anything from rattling around too much. I happened to use 40 copper clad lead weights that were about 147gn in weight, but you can use what every you have on hand. Screw the plug in with a flat blade screwdriver, then just use the large nut flange to move it from spool to spool.
Descripción original del autor, publicada en Thingiverse.
