Corn holders
por Gazzaladra en Thangs
A little helper for your next BBQ. Stop getting greasy fingers from eating delicious corn cobs. The texture provides a good grip.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Revisa las condicionesStandardDigitalFileLicense
El autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a Gazzaladra.
Archivos (7)
- corn_2,0.stl STL · 30,8 MB
- corn_2,2.stl STL · 30,8 MB
- corn_2,4.stl STL · 30,8 MB
- corn_2,6.stl STL · 30,8 MB
- corn_2,8.stl STL · 30,7 MB
- corn_3,0.stl STL · 30,7 MB
- corn_3,2.stl STL · 30,7 MB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 254
- Publicado
Sobre este modelo
A little helper for your next BBQ. Stop getting greasy fingers from eating delicious corn cobs. The texture provides a good grip.
Various hole sizes are provided for different toothpick diameters from 2,0 to 3,2 mm You have two options: 1. Choose your stl quite loose (diameter of the toothpick plus ca 0,4 mm depending on your printer’s accuracy) so the toothpicks get stuck in the cob when you remove the holder. This way you can then use the toothpicks as handle to throw the cob away without getting greasy fingers. 2. Choose your stl quite tight so the toothpicks don’t get loose when removing the holder and change them from time to time.
Instructions: - Choose your stl - Print at least two of the holders - Break or cut toothpicks in half - Insert them - Eat! - Remove the holders and throw away the cub
Size without toothpick: 25 x 25 x 36 mm
Print settings Material usage: 10g per pair Print time: 1h per pair
Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 20% Build plate adhesion type: none
Descripción original del autor, publicada en Thangs.
