Clamp compatible with BioRad gel
All I did was take Berendg's model https://www.thingiverse.com/thing:3268603 (url) and shrink the inner diameter of the hole. They made it 0.8 mm bigger than needed, so if your printer needs that clearance for the ID of holes, use the original. If you have your software set up so that you make this
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Uso comercial permitidoPuedes usarlo, modificarlo y venderlo manteniendo el aviso de copyright del autor.
Al descargar aceptas respetar la licencia y dar crédito a Marrett G.
Archivos (2)
- Clip.stl STL · 30 KB
- 20260517_101821.jpg JPG
- Categoría
- Educación
- Formatos
- STL, JPG
- Descargas
- 3
- Publicado
Sobre este modelo
All I did was take Berendg's model https://www.thingiverse.com/thing:3268603 (url) and shrink the inner diameter of the hole. They made it 0.8 mm bigger than needed, so if your printer needs that clearance for the ID of holes, use the original. If you have your software set up so that you make this clearance on your own and your prints match the true size of the model, use this one.
Descripción original del autor, publicada en Thangs.
