Church of Barovia (DND / TTRPG)

👍 Don't forget to Like and Collect this, so you can easily find it later! ⭐ If you like my models then come follow and support me on Patreon (https://goto.adamnant.com/l/patreon?site=thangs&model=corrupted_church1&cta=header) - where you'll get access to exclusive models.

One of the key structures that players will encounter early on in a Curse of Strahd campaign is the church of Barovia. Today I'm really happy to share the freemium version of this model with you all.

The premium textured version is a part of my Modular Barovia kickstarter campaign (https://goto.adamnant.com/l/modular-barovia-1?site=thangs&model=corrupted_church1&cta=teaser) that was successfully funded. You can buy it and the other structures from there, support me on Patreon for access to it on google drive or pick them up on some other sites that allow for model sales.

Modular Barovia kickstarter campaign (https://goto.adamnant.com/l/modular-barovia-1?site=thangs&model=corrupted_church1?site=thangs&model=corrupted_church1&cta=teaser)

This is still an initial release of the model so I have a few other updates planned for this including some more windows, more towers and modular sigil / emblems - when these are made depend on the feedback that comes on the set. Since it is a part of a modular set it's also compatible with my death house and several other modular sets that I've made (including the modular towers) and I've sized many of my props to fit nicely in these structures (but you can use your own too!).

Recommended Print Settings: - Important Note - there is a known issue with the Arachne wall generator - I know this is supposed to be better so I'm going to figure out what's wrong but for now, if your slicer uses Arachne, I recommend printing any walls that complain with the classic wall generator - 0.2mm on a 0.4mm nozzle - Wall Loops 2 - No Brim - unless you have trouble with adhesion and don't mind trimming parts - No Supports - you can set to critical only / thin tree supports, which might pick up some spots on the door arches and rooftop overhangs but don't let it add supports into the openlock holes (which it might want to do) these should be supportless - Infill Density 8% - you can go lower, even 5% should be fine

If you like these models you can follow me on Patreon here (https://goto.adamnant.com/l/patreon?site=thangs&model=corrupted_church1&cta=footer) to get sneak peaks at my upcoming projects, exclusive minis / models and more!