Christmas Tree Cake Belt Holster-EDC Snack Carrier

🎄 Tactical Holiday Tree Cake Belt Holster (Quick-Draw EDC Snack Carrier) Never get caught with a crushed holiday snack cake in your pocket again. Whether you're hanging lights, working in the shop, or just taking your festive snacking seriously, this Quick-Draw Holiday Tree Cake Belt Holster keeps your favorite frosted tree-shaped pastry safe, intact, and ready for immediate deployment. Engineered from the ground up for clean, hassle-free printing—and tuned for an effortless one-handed thumb release. ✨ Key Features

- One-Handed Quick-Draw Lid: Features a tuned slide-and-snap track (3.2 mm travel) and an integrated bottom thumb-push lip on the trunk. Just flick upward with your thumb to pop the lid off with one hand while it's clipped to your belt.

- Zero-Bleed, Opaque Frosting Lid: The 3.2 mm lid is designed with internal solidifier planes so your slicer prints a solid, non-translucent white core behind the 0.40 mm (2-layer) face inlay—keeping the red stripes crisp with zero infill shadow showing through.

- Heavy-Duty Side-Printed Belt Clip: The belt clip prints flat on its side so the layer lines run continuously around the hook loop for maximum strength, then slides and locks into the back of the holster base.

- Wrapper-Friendly Interior: Sized with generous clearance to hold a standard individually wrapped holiday tree cake without pinching the wrapper or squishing the frosting.

🖨️ Print Settings & Assembly

- Supports: Only on the clip (Keep supports unchecked!)

- Layer Height: 0.20 mm standard

- AMS / Filaments (3 Colors): - Slot 1: White PLA (Base, Belt Clip, and Lid Frosting)

- Slot 2: Red PLA (Lid Exterior Rim & Wavy Stripes)

- Slot 3: Green PLA (Lid Sprinkles)

- Print Orientation (Pre-oriented in the .3mf): - Base: Flat on its back

- Lid: Face-down on the build plate (use a textured PEI plate for a great matte frosting texture, or a smooth plate for a glossy icing look!)

- Belt Clip: Flat on its side for maximum hook strength

Assembly: Slide the twin-dovetail fingers of the belt clip up into the slots on the back of the base until flush and put a drop of glue to hold it in place. Drop in your wrapped tree cake, press the lid on, and slide it down 3 mm. 💼 Commercial / Selling Rights Want to sell physical prints of this design? You can grab commercial licensing and support future designs on my Patreon: 👉 https://www.patreon.com/c/hyperfixed123

Boost MeIf you enjoy this support-free design and want to see more functional everyday-carry (EDC) novelties, a Boost is greatly appreciated! Your support helps fuel future designs.Disclaimer: This is an independent fan-made novelty accessory and is not affiliated with, endorsed by, or associated with any snack cake brand or manufacturer.