Christmas Santa decoration (tealight compatible)

Modern and minimalistic Santa decoration, fun and stylish deco for this year's christmas season. All parts can be printed seperately, no need for MMU. The body of santa has a hole on the bottom to insert an electronic tealight, which will shine through the body and the face when using a translucent filament, creating a cosy look. Beard, tip and bottom of hat should be printed in fuzzy mode. Fuzzy mode settings: Beard: contour, 0.4mm point distance, 0,2mm skin thickness Hat tip and bottom: contour, 0.9mm point distance, 0,4mm skin thickness Assembly is straightforward and glue is not mandatory: First slide the beard over the body, then insert the nose. After this step you take the bottom strip of the hat and break the printed seam/gap to allow it to flex open and snap into the body of the hat. After this is done you can insert the top ball of into the hat body and put the hat on top of your Santa Claus!

If you want to support me or get commercial licenses you can join a patreon membership: https://www.patreon.com/SabreDesign For one time support you can also buy me a coffee here: https://buymeacoffee.com/sabredesign Check out more of my designs below and on my profile: