Christmas Door Trim Corner 60 - Santa Sleigh and Reindeer (Christmas ornament)
por MaxT en Printables
Print it. Hang it on the door, or window frame, or TV. Enjoy! Ho ho ho!
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a MaxT.
Archivos (1)
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 4,375
- Publicado
Sobre este modelo
https://www.buymeacoffee.com/maxt ---------------------- 4mm thick to ensure stability The model will fit on Prusa Mini+ (180x180) Feel free to size it up or down as you wish I strongly suggest sizing it up to fit your entire heat bed as it gives the best result The best quality is achieved if printed face down
Print: 0.2mm Nozzle: 0.4mm Support: Not needed Brim: Not needed Infill: Not needed, but I'd suggest going with 15% to ensure sturdiness A tip: If you want to get this print easily off your heat bed, place the heat bed with the printed model in the freezer for 10 to 30 mins. Take it out, and it should pop off quite easily without any breaks/cracks, as shown on the photo below :)
Happy Printing!
--------------
https://www.buymeacoffee.com/maxt
Descripción original del autor, publicada en Printables.
