Christmas decoration
por Pieter en Printables
Christmas decoration with lights. Fun easy project to make!
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Pieter.
Archivos (5)
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 6,153
- Publicado
Sobre este modelo
parts needed - White PLA or PETG - Glue - Batteries - White lights with battery holder (I used these) - 2mm foam
Assembly - Make 3 rectangles of 2x1 cm from the foam and stick them as in the photo. Take the lights and put them through the hole and press the battery holder in place.
2. Press the middle tree (2) into its slot and use hot glue to hang the light on it. It should look something like this. Note that for the best result you should orientate the lights towards the tree. I did not use all 20 lights, I cut the rest. 3. Press the small tree (3) and the deer (5) into its slot and glue the big tree (1) to the back. then it should be ready. If there are any problems, send me a message and I will do my best to help. Good luck and have fun printing
Descripción original del autor, publicada en Printables.
