Changing Pad Dispenser for the Nursery, Fluted
por Manic en Printables
Pull a changing pad out one at a time instead of digging through the packet. Fluted box, lift-off lid, printed knob.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Manic.
Archivos (4)
- Categoría
- Hogar
- Formatos
- SCAD, STL
- Descargas
- 0
- Publicado
Sobre este modelo
Holds a stack of 190 x 130mm changing pads and gives them out one at a time through the slot at the front. Lift the lid to refill.
Cavity 135 x 195mm
Outside 142.8 x 202.8 x 150mm
Other pad sizes: change the two numbers at the top of the .scad. Knob fixes with one M3 x 12-16mm screw from inside the lid. Note in the picture, I my filament got stuck and I had to repair the print, but the real print should come out just fine! and I also ran out of white and replaced it with red instead, hence the color change.
Descripción original del autor, publicada en Printables.
