Chair Leg 15 degrees 13mm
por Slowmoe en Printables
Chair Leg 15 degrees 13mm using 21mm superglued filt pads.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Slowmoe.
Archivos (2)
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
21mm leg feet for Søstrene Grene chairs. For use with 21mm adhesive filt pads, that I superglue. Should also work with any other generic chairs with 13mm inner dimmension and 15 degree leg angle. 8/7-26 I have been keeping the chairs alive with these for 5 years now. Sometimes I just glue a new adhesive, but I have since printed them in PETG, because one or two has snapped through the years. I have been through several revisions but ended up back on this simple one, and shared the final outcome as "V2".
Descripción original del autor, publicada en Printables.
