Case for Hackaday Supercon 2026 Billboard Badge
por Daniel James en Thingiverse
This design is based on the front bezel design shared at https://github.com/Hack-a-Day/2026-Billboard_Badge/blob/main/hardware/billboard_mockup-Frame.step, but with a back cover over the LiPo battery. There are known fit issues with this design, but they do not affect the ability of the case to...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Daniel James.
Archivos (3)
- Categoría
- Varios
- Formatos
- STEP
- Descargas
- 0
- Publicado
Sobre este modelo
This design is based on the front bezel design shared at https://github.com/Hack-a-Day/2026-Billboard_Badge/blob/main/hardware/billboard_mockup-Frame.step, but with a back cover over the LiPo battery. There are known fit issues with this design, but they do not affect the ability of the case to protect the badge. More info at https://thzinc.com/2026/11/09/hackaday-superconference-2026-days-1-2-billboard-badge-case.html The design uses the following hardware: - (5) 4mm tall M2 heat set brass inserts - (3) 10mm M2 bolts - (2) 20mm M2 bolts
- Install three heat set inserts in the bezel - Install two heat set inserts in the edge of the back cover - Place badge in bezel - Place back cover over badge and secure with three 10mm M2 bolts - Place end cap over left edge and secure with two 20mm M2 bolts
Descripción original del autor, publicada en Thingiverse.
