Cantilever Suspension for Axial SCX10

I made this Cantilever Suspension to remove the rear shock towers so you can have more options for bodies on you Axial SCX-10.

My Main goal was to use the stock shocks to keep the cost down. You will need to print the parts and purchase a couple nuts and bolts. But overall cost is really inexpensive. Plus if anything breaks you can always print a new part!

Here is a list of parts that are needed to complete this project.

Printed Parts: 1 x Base 1 x Mount Left - Glue to "Base" part 1 x Mount Right - Glue to "Base" part 2 x Pivot 1 2 x Pivot 2 2 x Spacer 1 2 x Spacer 2

Bought Parts: 2 x M3 40mm bolt 2 x M3 nut 4 x M2 16mm bolt 4 x M2 nut (you can use M3 bolts and nuts instead of M2, you just need to drill the holes a little bigger)

Bought or made Part: 2 x Push rods 28mm long from center of ball joint to center of ball joint --- For the Push rod (the connection between the cantilever itself to the axle), I used the extra rod ends that you get when you buy a SCX10