Calla Lily Flower (Vase Mode)
Print one of each (my settings are below). Then place the spadix inside the flower flat side down and push the bumps through the hole in the bottom of the flower until it stops. Then align the bumps on the spadix with the bumps on the top of the stem and snap them together. You may wish to add glue
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Revisa las condicionesStandardDigitalLicense
El autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a Michael G.
Archivos (3)
- VaseMode_CallaLilly_Flower.stl STL · 682 KB
- VaseMode_CallaLilly_Stem.stl STL · 72 KB
- VaseMode_CallaLilly_Spadix.stl STL · 16,8 MB
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 563
- Publicado
Sobre este modelo
Print one of each (my settings are below). Then place the spadix inside the flower flat side down and push the bumps through the hole in the bottom of the flower until it stops. Then align the bumps on the spadix with the bumps on the top of the stem and snap them together. You may wish to add glue for a sturdier more permanent assembly.
If the stem is too tight you can play with the scale of the parts until you get a nice tight fit for your machine.
Below are my print settings:
Flower: - Spiral vase mode - top layers: 0 - bottom layers: 4 - extrusion width: 0.6 (for sturdier model) - brim: 'Outer brim only', 5mm width
Spadix: - Spiral vase mode - top layers: 0 - bottom layers: 4 - extrusion width: 0.6 (for sturdier model) - brim: 'Outer brim only', 5mm width
Stem: - Spiral vase mode - top layers: 0 - bottom layers: 0 (zero bottom layers is important for snapping the flower together) - extrusion width: 0.6 (for sturdier model) - brim: 'Outer brim only', 5mm width
Descripción original del autor, publicada en Thangs.
