CableManager

If your device / Ethernet / power cables all too often ends up in a tangled mess then do yourself a favour and print a CableManager! This simple device prints in around 15 minutes (on a MakerBot), uses very little filament, and quickly clips into place on your devices power cable. Refer to the images for the recommended sequence. Once installed in this order you can unclip the length of cable required from each end to manage the length of cable as required... and secure it in a tidy coil when all clipped back in place. A quick and easy solution that keeps your devices power cable under control. At standard scale the CableManager works with 6.75mm diameter power cables which are common for laptop power supplies. Scale up/down as required to suit other common cable sizes. A second .stl has been added that is designed to suit Ethernet cables and functions in exactly the same way. For example, with Ethernet Cables decrease the X/Y scaling by 22% (78% of standard) to use with 5.25mm cables which are the common/average Ethernet size Note: Cables vary in diameter so you may need to test a couple to get them perfect for your cables. Only uniform X/Y scaling is recommended as Z scaling will affect the strength and flexibility of the CableManager. A great way to keep your power cable tidy, adjusted to the length required and tangle free. Note: If you like this check out all my other practical and fun designs. Tips: Tips are not expected but are appreciated as they help offset my filament costs as much as anything else. However, as I live outside the USA tips cannot be sent to me via PayPal.Me as that service is not supported in my region and this is beyond Thingverse's control. If you feel like sending a tip please use regular PayPal and send it to [email protected] and, to those who do, thanks in advance!