Cable Winder with Plug Tray | 3 Sizes
por Movses Movsesyan en Printables
One-piece cable winder with a flared rim, four routing slots, and a recessed plug tray with 3 different sizes.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Movses Movsesyan.
Archivos (6)
- Cable_Winder_Medium_V3_Open_Center.stl STL · 392 KB
- Cable_Winder_Medium_V3_Open_Center.step STEP · 928 KB
- Cable_Winder_Large_V3_Open_Center.stl STL · 404 KB
- Cable_Winder_Small_V3_Open_Center.stl STL · 458 KB
- Cable_Winder_Small_V3_Open_Center.step STEP · 928 KB
- Cable_Winder_Large_V3_Open_Center.step STEP · 915 KB
- Categoría
- Organización
- Formatos
- STL, STEP
- Descargas
- 1
- Publicado
Sobre este modelo
Wrap the cable around the waist and tuck both plugs into the center tray. The flared rim keeps the coil in place, and four rounded slots let you wind in either direction. Finger recesses make it easier to lift out the plugs. Choose a size - Small about 1 m at Ø4.2 mm · 42 × 20 mm plug tray
- Medium about 1.5 m at Ø6 mm · 59 × 30 mm plug tray
- Large about 2 m at Ø8 mm or 3 m at Ø6 mm · 80 × 39 mm plug tray
Measure the cable jacket and check that both plugs fit. Capacity varies with cable stiffness and plug size. Print settings Print flat with supports off. Start with PLA, a 0.4 mm nozzle, 0.20 mm layers, 3 walls, and 15–20% infill. Each size prints in one piece. Editable STEP files are included.
Descripción original del autor, publicada en Printables.
