BUTTER FINGERS - Butter Jewelry Organizer

A little butter. A place for your jewelry.

BUTTER FINGERS turns an everyday butter dish into a playful home for your everyday jewelry. Slip your rings over the little butter-knife handle, tuck your studs into the shallow melted-butter recess, and keep your small favorites together on the rounded tray.

Soft curves, a tiny puddle and three simple colors. A useful little detail for your dresser, bedside table or vanity.

ONE PIECE. ONE PLATE. The dish, butter and decorative knife form one connected print. No screws, glue, magnets or assembly. The three colors are material regions within the same model, not separate parts to put together. The knife is fixed in place.

WHAT’S INCLUDED • One editable 3MF project: one plate, one multicolor object. • One merged STL for single-color printing or optional painting. • A direct Blender geometry reference. • Personal-use and commercial-print license documents. This is a digital download, not a finished physical product. Jewelry and other styling props are not included as printable models.

SIZE & FIT 150 × 110 × 113.5 mm (approximately 5.91 × 4.33 × 4.47 inches). The knife handle has a maximum cross-section of approximately 12 × 7.2 mm. Check that your rings can pass over the handle; ring fit and capacity have not been physically tested. The little recess is intended for small studs and similar jewelry.

PRINTING Print upright with the flat underside of the dish on the build plate. The supplied project uses ivory, butter yellow and warm gray PLA with AMS or a compatible multicolor system. Without AMS, use the merged STL for a one-color print.

Reference settings: 0.4 mm nozzle, 0.16 mm layers, 3 walls, 12% gyroid infill, 6 top layers and 5 bottom layers. Supports are disabled. The complete model fits within a 250 × 250 × 250 mm build volume.

The 3MF uses a Bambu X1 Carbon 0.4 mm reference profile. Select your own printer, plate and filament settings, then re-slice. It contains editable geometry, not ready-to-print G-code. Keep the color regions grouped as one object.

SLICER ESTIMATE Approximately 5 hours 14 minutes and 111 g of PLA, including flushing and the prime tower, with 32 filament changes in the reference profile. Your results will vary with printer, material and settings.