Business Card Embosser - Level up your cards!
por Makerspace.Online en MakerWorld
A 3D printable Businesscard embosser, can be assembled without any hardware, everything just snaps together.
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Makerspace.Online.
Archivos (14)
- Embosser_knob.stl STL · 676 KB
- Embosser_Confetti negative.stl STL · 2,8 MB
- Embosser_Gear1.stl STL · 763 KB
- Embosser_Gear2.stl STL · 763 KB
- Embosser_Zigzag Negative.stl STL · 1,1 MB
- Embosser_Gear3.stl STL · 762 KB
- Embosser_Confetti Positive.stl STL · 3,1 MB
- Embosser_Gear 4.stl STL · 753 KB
- Embosser_Polkadot Negative.stl.stl STL · 1,2 MB
- Embosser_Body Top.stl STL · 891 KB
- Embosser_Zigzag Positive.stl STL · 1,1 MB
- Embosser_Polkadot Positive.stl STL · 1,0 MB
- Embosser_Body.stl STL · 1,7 MB
- Embosser extended handle.stl STL · 1,2 MB
- Categoría
- Hogar
- Formatos
- STL
- Descargas (todas las plataformas)
- 26,491
- Publicado
También en
Sobre este modelo
A 3D printable Businesscard embosser, can be assembled without any hardware, everything just snaps together. I designed this businesscard embosser to be modular and 3D printable without using any support and without any hardware required to assemble.
The tollerances are tight. And some materials work better then others. I have had best results using Basic PLA.
Available patterns: 3 Rollers available, more patterns can be found on my makerworld page! - Confetti - ZigZag - Polkadot
NOTE: This design is licensed under a Creative Commons Attribution-Noncommercial-Share Alike Please do not sell this file or printed product.
Want a Commercial Licence? Become a member of my Patreon page!
Assembly: (Pro tip: use some lubrication grease / vaseline around the gears for a better working!!)
Make sure to allight the bottom gears maked with the dot and allign with the stipe. Do not forget to add some lubrication / grease between and underneath the gears!
For the top gears some marks are present as well to allign the gears properly! Also here! Do not forget to add some lubrication / grease between and underneath the gears!
Note: This design is licensed under a Creative Commons Attribution-Noncommercial-Share Alike Please do not sell this file or printed product. Want an commercial Licence, visit my Patreon!
Patreon:
Instagram:
Descripción original del autor, publicada en MakerWorld.
