DJI Mavic Pro Clone
por Steve Wagg en Thingiverse
NOTE - UPDATED VERSION AVAILABLE ON http://diyrc.co.uk A couple of the photos are from the updated version (LED's at the back). Following on from my Inspire Clone I decided to have a go at the DJI Mavic.. This time it's a little different as I actually have one to measure and compare with so the...
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Steve Wagg.
Archivos (13)
- Catch.stl STL · 12 KB
- Feet_left.stl STL · 29 KB
- Leg_back_right.stl STL · 81 KB
- Leg_front_left.stl STL · 109 KB
- Top_Back.stl STL · 18 KB
- Nose.stl STL · 150 KB
- Middle.stl STL · 145 KB
- Feet_right.stl STL · 29 KB
- Top_front.stl STL · 66 KB
- Feet_rear.stl STL · 28 KB
- Leg_front_right.stl STL · 109 KB
- Bottom.stl STL · 258 KB
- Leg_back_left.stl STL · 81 KB
- Categoría
- Repuestos
- Formatos
- STL
- Descargas (todas las plataformas)
- 58,829
- Publicado
También en
Sobre este modelo
NOTE - UPDATED VERSION AVAILABLE ON http://diyrc.co.uk A couple of the photos are from the updated version (LED's at the back). Following on from my Inspire Clone I decided to have a go at the DJI Mavic.. This time it's a little different as I actually have one to measure and compare with so the clone is even better this time. I've tried to make this an easy print with no support required, all items are rotated ready to print. Please visit my website for updated versions, build logs and more.... Printed at 0.3 / 30% for speed, although it does seem very strong I'll drop this down to 0.2mm / 30% for final print.
Descripción original del autor, publicada en Thingiverse.
