Birdfeeder with food silo to hang up or for standing, e.g. on the window sill

Birdfeeder with food silo. The food is stored in the building and slides in automatically when the birds eat in front. The roof is removable and is held in place by both the overhang and 8 magnets.

You also need a piece of transparent foil (approx. 10x5cm), e.g. laminating foil. Cut the foil to size and stick it against the windows from the inside (these are the "window panes"). Also 8 cylindrical neodymium magnets 4 mm in diameter, 5mm long.

Print the roof upright (leave out the supports in the holes), this will look best. The building can be printed without supports if you have a good printer, but if you want to put some under the front wall (where the food slides through) and in the windows

The bird house can be put up or hung up. If you want to put it up, close the holes with extra plugs so that no food comes out. You should then secure it with wire or string that you pull through the triangular tunnel.

It is best to print in PETG so that the house is stable even in summer when the sun shines on it.

I hope you like my (first) construction. If you have any suggestions for improvement, please write to me.

Have fun printing!