Bike Airtag holder
por David Kidd en MyMiniFactory
Under seat Airtag holder for bikes that use a standard rail mount to the seat post.
MyMiniFactory entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a David Kidd.
Archivos (1)
- Half V10.3Mf 3MF
- Categoría
- Jardín
- Formatos
- 3MF
- Descargas
- 1,256
- Publicado
Sobre este modelo
Under seat Airtag holder for bikes that use a standard rail mount to the seat post.
M5 6 sided nut and bolt needed to clamp around seat rails. Print the half twice, push airtag into the circular area and screw the two halves together around seat rails.
I added a small bit of foam tape to the rails to give more grip between the holder and rails but its not needed.
No supports needed on my machine. Printed in ASA
Descripción original del autor, publicada en MyMiniFactory.
