Bifold Door Holder, 15 to 75 Degrees, 35 mm Panels
A cap for the top of a bifold door that holds the two panels open at a fixed angle. Six angles: 15, 30, 45, 60, 65 and 75 degrees, one file each. Fold the door to that angle, then press the holder down over the top edges at the hinge.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-ND 4.0 — Atribución, no comercial, sin derivadas
Solo para uso personal, sin modificarlo y dando crédito. No se permite vender ni redistribuir cambios.
Al descargar aceptas respetar la licencia y dar crédito a CoCo.
Archivos (12)
- bifold_door_holder_65deg.stl STL · 9 KB
- bifold_door_holder_65deg_X2D.3mf 3MF · 194 KB
- bifold_door_holder_15deg.stl STL · 6 KB
- bifold_door_holder_15deg_X2D.3mf 3MF · 156 KB
- bifold_door_holder_30deg.stl STL · 8 KB
- bifold_door_holder_30deg_X2D.3mf 3MF · 171 KB
- bifold_door_holder_45deg.stl STL · 8 KB
- bifold_door_holder_45deg_X2D.3mf 3MF · 185 KB
- bifold_door_holder_60deg.stl STL · 9 KB
- bifold_door_holder_60deg_X2D.3mf 3MF · 196 KB
- bifold_door_holder_75deg.stl STL · 9 KB
- bifold_door_holder_75deg_X2D.3mf 3MF · 186 KB
- Categoría
- Jardín
- Formatos
- STL, 3MF
- Descargas
- 0
- Publicado
Sobre este modelo
A cap for the top of a bifold door that holds the two panels open at a fixed angle. Six angles: 15, 30, 45, 60, 65 and 75 degrees, one file each. Fold the door to that angle, then press the holder down over the top edges at the hinge.
Fit - For panels 35 mm thick, hinged with about a 5 mm gap between them - Slots 35.5 mm wide, 20 mm deep; 94 to 111 mm wide, 24 mm tall - Measure your door first; the drawing shows the 65 degree one
Printing - PLA, 0.2 mm layers, no supports. Prints top down as provided. - An STL and a Bambu Studio 3MF (X2D) for each angle; each prints in under an hour.
Descripción original del autor, publicada en Thangs.
