Bed Debris Shield for Elegoo Centauri Carbon
por MagicShrimp en Printables
Covers that can be installed on the Elegoo Centauri Carbon to stop debris from getting under the bed.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a MagicShrimp.
Archivos (4)
- Categoría
- Para tu impresora
- Formatos
- STL, STP
- Descargas
- 562
- Publicado
Sobre este modelo
*It appears that Elegoo has changed the design of the bracket that these were meant to mount to. Check to make sure your bracket is the same length as mine in the picture or these will not work.
Small covers that can be installed to block debris from getting trapped under the bed of the Elegoo Centauri Carbon. Made these after a piece of a support got stuck under there when I scrapped it off.
Uses the screws that are already in place, does not effect bed leveling. Note that the debris cover for the rear is slightly longer.
Required STLs: 2x debris_cover_lr 1x debris_cover_rear
Required Hardware: None
Descripción original del autor, publicada en Printables.
