Balloon Dog Magnet
por TheCraftyMaker en Thangs
A balloon dog magnet.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a TheCraftyMaker.
Archivos (1)
- Balloon Dog Magnet v8.stl STL · 4,4 MB
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 154
- Publicado
Sobre este modelo
A balloon dog magnet.
This print requires 4 round magnets of width 6mm and height 3mm. To install the magnets, put a pauze just before the holes for the magnets are covered up when slicing.
Supports needed when printing. Be careful when removing the supports from the nose, this is the most fragile part of the model.
_ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Companion subscription._
Descripción original del autor, publicada en Thangs.
