BagAir – Zip Bag Drying Bridge
por RaiVollD en Printables
A one-piece bridge designed to keep a rinsed zip bag open, with raised ribs and no drip tray.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a RaiVollD.
- Categoría
- Hogar
- Formatos
- 3MF, STEP, STL
- Descargas
- 5
- Publicado
Sobre este modelo
I designed BagAir to deal with a small annoyance: the wet sides of a rinsed zip bag tend to stick together when I leave it to dry.
The idea is simple. Put the bag over the rounded bridge with its opening facing down. Three raised ribs are intended to hold the film away from the main arch and leave space for air between them. There is no tray underneath, so water can drip onto the draining surface below.
It is a single piece, with two broad feet and no clips or moving parts.
### Size
- Overall: **134 × 70 × 69 mm** in use. - Main arch: 30 mm deep, with a 6 mm wall. - Three ribs: 4 mm wide and 6 mm above the main arch. - Rounded outer contact edges. Scale the model for different bag sizes.
Descripción original del autor, publicada en Printables.
