Automatic vegetable and fruit washer- no supports and no assembly required. Small and large sizes
por GiskardReventlov en Printables
Set under the tap and watch the vegetables spinning on it. Prints in one piece with no supports.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a GiskardReventlov.
Archivos (6)
- Categoría
- Hogar
- Formatos
- 3MF, STL, STEP
- Descargas
- 31,624
- Publicado
Sobre este modelo
Modeled from scratch, inspired by lwx007's design: Thingiverse #5685812 I saw some comments about difficulties with the original model requiring assembly or gluing, and decided to make a model that can be printed in a single piece and without any support, since PETG doesn't handle supports well. - Two sizes available:- Small → for small berries, small leaves, and small portions of grapes and cherry tomatoes - Large → for larger salad leaves and larger berries, or large portions of grapes and cherry tomatoes
- Works better in PETG (PLA may leak) - The walls are made thin to save material and print fast, but it's perfectly strong in the default sizes. Be careful when resizing the design - If your sink has low flow, you may need to block some of the drain holes
Made on Onshape. Step files included.
Descripción original del autor, publicada en Printables.
