Auto-Resetting Target | Nerf, Airsoft, and more
por Rexi Labs en MakerWorld
This is the ultimate auto-resetting target collection! It includes over 6 different types of interchangeable targets, and each tips over when you shoot it before auto resetting. You only have to print the base once, and then you can swap out targets whenever you want. There's even two different…
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalStandard Digital File License
Licencia estándar de archivos digitales: solo uso personal. No se permite compartir, revender ni subir el archivo a otros sitios, ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Rexi Labs.
- Categoría
- Jardín
- Descargas
- 19
- Publicado
Sobre este modelo
This is the ultimate auto-resetting target collection! It includes over 6 different types of interchangeable targets, and each tips over when you shoot it before auto resetting. You only have to print the base once, and then you can swap out targets whenever you want. There's even two different sizes, a larger version and a smaller version. No AMS is needed. Bambu filaments For normal velocity rounds, most nerf, etc, regular PLA is fine. But if you find your target isn't holding up, you may want to try PLA Tough+ or something similar.
PLA Tough+ is recommended for higher velocities It has 2.5x the impact resistance of normal PLA.
- Target Stand - Matte Black for normal velocities or Tough+ Black for high velocities
- Duck Target - Matte Yellow for normal velocities or Tough+ Yellow for high velocities
- Matte Red or Tough+ Orange
- Matte White for normal velocities or Tough+ White for high velocities
- Red/White/Blue targets - Matte Red or Tough+ Orange
- Matte Blue for normal velocities or Tough+ Blue for high velocities
- Matte White for normal velocitiesor Tough+ White for high velocities
- Splat Target - Matte Yellow for normal velocities or Tough+ Yellow for high velocities
- Matte Blue for normal velocities or Tough+ Blue for high velocities
- Matte White for normal velocities or Tough+ White for high velocities
- Matte Red or Tough+ Orange
Simply snap targets into the stand to use it All of the targets can be snapped into the stand with ease and then removed just as easily. You just need to flex the stand slightly to get it in and out.
For some of the speciality targets there's minor assembly that takes a few seconds.
Weighted target For this target, simply screw the the counter weight in on either side of the stick hanging down from the target through the bottom hole. Then snap the target into the base/stand.
Segmented target For this target, slide the bar through the holes in the target segments.
Then attach the little ring on the other side to secure it before snapping the target into the stand/base.
Descripción original del autor, publicada en MakerWorld.
