Arduino Mega 2560 Snug Case
por Scott Shumate en Thingiverse
A snug fitting case for the Arduino Mega 2560 with screw board mounts and a snap top. Shields may be installed over the top of the case. There are four holes on the top to view the four LEDs on the Arduino board. These holes can accommodate Bivar PLP2-250 light pipes for a more polished look. The...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Scott Shumate.
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 30,791
- Publicado
Sobre este modelo
A snug fitting case for the Arduino Mega 2560 with screw board mounts and a snap top. Shields may be installed over the top of the case. There are four holes on the top to view the four LEDs on the Arduino board. These holes can accommodate Bivar PLP2-250 light pipes for a more polished look. The screws for the Arduino board are #2 x 1/4" thread rolling screws. This case was derived from my Arduino Uno Snug Case. For the Raspberry Pi, see my Raspberry Pi Snug Case.
Descripción original del autor, publicada en Thingiverse.
