Apple Watch Charger Cord Winder Case / Stand

Apple Watch Charger Case With Cord Winder. This is a Print in Place cord winding case for Apple Watch chargers. Two separate models to work with variations in Apple Watch Chargers.

I have also added the gcode and 3mf files for the color changes prints pictured.

Note Multiple Models: Two Models available depending on the Apple Watch charger you have, White Plastic casing 8mm Metal Casing 6.5mm

Assemble: Align inside and outside holes and thread the USB end of the cable through. Align the cable end of the charger in the center of the holes going through the side and push that end down first. Then firmly push the opposite side of the charger from the cable down to snap into place.

Charger Removal: To remove the charger push up from the bottom on the side opposite of the cable and reverse the steps to insert.

Printing: When printing a good first layer calibration is important. If you have to much squish the inside and outside parts will be fused together.

Print Settings: Printed in PETG 0.2mm 40% infill