Anycubic Kobra 3 Side Cable Chain for Stock Camera Mount
por JJ Irons en Printables
Contain your wires with this cable chain for the Kobra 3. Designed to replace the stock camera mount!
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a JJ Irons.
Archivos (4)
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas (todas las plataformas)
- 4,999
- Publicado
También en
Sobre este modelo
This model uses 22 links, 22 covers, 1 end, and 1 start. I printed mine from PLA. Some supports are needed on the start and end. This chain clips into the aluminum extrusion under the printer just like the existing wire managers. Thread the camera USB cable through these and then stick it into the cable chain with everything else. The top of the chain replaces the existing camera mount. If you don't have a camera, just use a single small screw to hold it in place (and then go get the camera, it's nice).
Good luck and happy printing!
Descripción original del autor, publicada en Printables.
