Anker Prime Charger 200W – Cable Management
por SixC en Printables
I bought the Charger because I got tired of the charging snake pit that was constantly lying around on my windowsill.
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a SixC.
Archivos (1)
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
I bought the Anker Prime Charger 200W because I got tired of the charging snake pit that was constantly lying around on my windowsill. 😄 So I designed this little add-on to keep the cables under control and make the whole setup look a bit less chaotic. 🛠 Print Settings - 🧱 Material: PLA / PETG
- 📏 Layer height: 0.20 mm
- ⚙ Infill: Structural
- 🖨 Supports: not nesse
- 🔧 Status: Work in Progress
The model is still being developed, so improvements and new versions may come in the future. 💡 Notes Designed specifically for the Anker Prime Charger 200W. If you have any suggestions or ideas for improvements, feel free to leave a comment.
Descripción original del autor, publicada en Printables.
