Ancient Pokeball from Pokemon Legends: Arceus Version 2
Model Description
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a Jacob P.
Archivos (17)
- arceus_heavy_ball_top.stl STL · 1,6 MB
- arceus_heavy_ball_top_sd_covers.stl STL · 2,0 MB
- v2 ball bottom (flat bottom).stl STL · 1,4 MB
- v2 ball bottom (rounded bottom).stl STL · 1,6 MB
- v2 ball top.stl STL · 1,5 MB
- v2 front emblem bottom.stl STL · 1,2 MB
- v2 front emblem top.stl STL · 1,2 MB
- v2 latch.stl STL · 672 KB
- v2 rings.stl STL · 803 KB
- v2 small notch.stl STL · 49 KB
- v2 steam valve.stl STL · 1,0 MB
- v2 switchinsertbottom.stl STL · 549 KB
- v2 switchinserttop.stl STL · 642 KB
- v2_DS_insert_bottom.stl STL · 538 KB
- v2_DS_insert_top.stl STL · 475 KB
- v2_SD_card_insert_bottom.stl STL · 549 KB
- v2_SD_card_insert_top.stl STL · 659 KB
- Categoría
- Cosplay y props
- Formatos
- STL
- Descargas
- 364
- Publicado
Sobre este modelo
Model Description
Version 2: This complete remake was in response to the issues with Version 1 and there are a few big changes. First thing, the design is 100% support free, unlike Version 1 which needed supports in a few places. The hinge is also now print in place as opposed to the "snap-into-place" hinge on Version 1, which makes the ring assembly much stronger. The locking mechanism is now much stronger so very unlikely to break or come loose, but the components are also designed to be replaced easily if needed. The only major con I would say to Version 2 is that it isn't quite as "screen-accurate" as Version 1, which was the one minor sacrifice I had to make to make the necessary improvements.
Version 2 STL's: - Ball Top - Ball Bottom (Flat Bottom) - Ball Bottom (Rounded Bottom) - Rings - Front Emblem Top - Front Emblem Bottom - Stream Valve - Small Notch - Latch - Nintendo Switch Inserts (2 Pieces, 16 Games + 8 Micro SD) - Nintendo DS Inserts (2 Pieces, 10 Games) - SD/Micro SD Inserts (2 Pieces, 12 SD Cards + 12 Micro SD)
Support: Version 2 is 100% Support Free
Assembly: Assembly video for Version 2 Can Be Found Here: https://www.tiktok.com/@thinair3d/video/7076937385111670062?is_copy_url=1&is_from_webapp=v1
Troubleshooting: If you are having pieces fuse together (mainly the hinge), you are likely over extruding. I would suggest calibrating your eSteps/Flow and try again. You will also need to verify that your bridging is decent, otherwise that could also cause the hinge to fuse.
-If you are still having issues, please feel free to message or email me and I will see what I can do to help!
Descripción original del autor, publicada en Thangs.
