Ana's Biotic Rifle from Overwatch
por Casual Props en MyMiniFactory
Ana's rifle from Overwatch.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Casual Props.
Archivos (33)
- Ana Ammo 1V3.Stl STL
- Ana Ammo1 1.Stl STL
- Ana Ammo2 1.Stl STL
- Ana Barrel1 1.Stl STL
- Ana Barrel2 1.Stl STL
- Ana Barrel4 1.Stl STL
- Ana Barrel5 1.Stl STL
- Ana Barrel6 1.Stl STL
- Ana Bayonet1 1.Stl STL
- Ana Bayonet2 1.Stl STL
- Ana Bayonet4 1.Stl STL
- Ana Bayonetclip 1.Stl STL
- Ana Bayonetsupport 1.Stl STL
- Ana Chamber1 1.Stl STL
- Ana Grip 1.Stl STL
- Ana Hammer 1.Stl STL
- Ana Handle 1.Stl STL
- Ana Handle1 1.Stl STL
- Ana Handle2 1.Stl STL
- Ana Handle3 1.Stl STL
- Ana Handle4 1.Stl STL
- Ana Holder 1.Stl STL
- Ana Scope 1.Stl STL
- Ana Side1 1.Stl STL
- Ana Side2 1.Stl STL
- Ana Side3 1.Stl STL
- Ana Side4 1.Stl STL
- Ana Striker1 1.Stl STL
- Ana Striker2 1.Stl STL
- Ana Striker3 1.Stl STL
- Ana Striker4 1.Stl STL
- Ana Trigger 1.Stl STL
- Ana Trigger1 1V2.Stl STL
- Categoría
- Cosplay y props
- Formatos
- STL
- Descargas
- 3,639
- Publicado
Sobre este modelo
Ana's rifle from Overwatch.
I've tried to keep supports to a minimum while also getting as much details as I can on each part.
There are slots for 6x3mm magnets on the handle and barrel to make it easier to travel with. There's space in there for 2 stacked ontop of eachother.
I printed the parts at 0.15-0.2mm layer height, 2 perimeters at 8% infill in ABS and acetone-welded the flat surfaces together. In hindsight, adding some pegs to align them better would have been better. So I'm trying that out on my next print.
I went through about 2/3rds of a spool printing this, so with supports I think it was around 600-700g total. (possibly less since I had to redesign and reprint some fragile parts).
Descripción original del autor, publicada en MyMiniFactory.
