Among Us (easy print)(crew/body/ghost/impostor)

Among us crewmates don't have a consistent style, and of all the models that I found, non of them was spot on what I had in mind when I think about the Among us crewmates. So I decided to make my own. At first I wanted to make a realistic version while keeping the overall shape. But every detail you add detracts from that distinctive shape. At last I only took artistic liberties with the impostor. It was printed slow (50 mm/s) at low temp (190 Cº) and at 0.08 layer height. the results are super smooth. I only sanded the tip of the heads were the layer stepping is more notorious and were the suports make contact. most of the suport make contact at 45º so the scarring is minimum. I added a pic with the orientation of each part. other thand that, the paint should be enough to cover the lines. Most parts have only one color for easy painting. Exept the megaphon and the impostor teeth. The "lock" piece it's made for aligning the top and bottom halves of the body. It has a cut to allow flexibility on low tolerance machines. You can glue it on the top half leaving a few millimeter outside to couple with the lower half. NOTE: prusaslicer can't handle obj's very well. open them in 3d builder or mesh mixer and save them as stl. This model is under "Attribution + Noncommercial + ShareAlike" You can't sell this model on etsy/ebay/etc.. If you want to print and sell this model first contact the IP owners, ask for their permission, and then contact me.