AKG HT4500 microphone sleeve
por David Byrne en Thingiverse
Like many commercial microphones, the weak point is in the battery cover or sleeve. Replacing the batteries many times and using a little too much force cracks the case. I designed this sleeve to replace the original. It is at tough as nails, even strong than the original if printed in PETG...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a David Byrne.
Archivos (1)
- Categoría
- Tecnología
- Formatos
- 3MF
- Descargas
- 1
- Publicado
Sobre este modelo
Like many commercial microphones, the weak point is in the battery cover or sleeve. Replacing the batteries many times and using a little too much force cracks the case. I designed this sleeve to replace the original. It is at tough as nails, even strong than the original if printed in PETG, although, PLA+ is good too. It is a breeze to spin on the microphone body, and is designed not to crack. Singers have no issues with this cover. Make sure you print it with the narrow end on the bed, with the wider end with the course thread upwards.
Descripción original del autor, publicada en Thingiverse.
