Airsoft Pistol Stand for Glock | Fork Base | Fits the Mag Well | No Supports
por gregexe en Printables
Desk stand for Glock-type airsoft pistols: a tongue slides into the magazine well. Fork base, prints with no supports.
Licencia
Solo uso personalStandard Digital File License
Licencia estándar de archivos digitales: solo uso personal. No se permite compartir, revender ni subir el archivo a otros sitios, ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a gregexe.
Archivos (1)
- Categoría
- Jardín
- Formatos
- STL
- Descargas
- 2
- Publicado
Sobre este modelo
Desk stand for Glock-type airsoft pistols: the pistol stands upright on a tongue that slides into the magazine well. A faceted block holds the grip, and two feet fan out from its front faces and run under the slide, where the weight is. The pistol sits on the whole base of its grip, upright and steady, with the gregexe crosshair engraved on the front. Features - Footprint: 130 × 122 mm, height 92 mm
- Tongue: 33.0 × 22.7 mm section, 60 mm long, angled 12° like the magazine well
- The two feet start from the faces of the block and reach under the slide, so the pistol does not tip forward
- One piece, prints flat with no supports
Compatibility - Made for airsoft pistols that take Glock-type (G17 / G18 style) magazines.
- Tested on an Action Army AAP-01 and on a Glock airsoft pistol.
- Measure your magazine well before printing: the tongue is 33.0 × 22.7 mm.
Printing - Material: PLA+ or PETG
- Orientation: flat on the bed, as in the STL file
- Supports: none
- Suggested: 0.2 mm layers, 3 walls, 15 % infill
Files - gregexe_glock-stand-fork_v2.stl: the stand, ready to print
Important Display stand for airsoft replicas only. Remove the magazine and make sure the replica is safe before placing it on the stand. My other airsoft files: www.gregexe.com
Descripción original del autor, publicada en Printables.
