AirPods 1 & 2 Stand | Sprout, One Piece Holder
por FAMER en MakerWorld
A small sprout for your desk: two arms grow out of a single stem and each one ends in an open collar that the AirPod stem slides into. The buds hang nose-up, the way they sit in the case, so you pick them up the right way round without looking.
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalStandard Digital File License
Licencia estándar de archivos digitales: solo uso personal. No se permite compartir, revender ni subir el archivo a otros sitios, ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a FAMER.
- Categoría
- Herramientas
- Descargas
- 0
- Publicado
Sobre este modelo
A small sprout for your desk: two arms grow out of a single stem and each one ends in an open collar that the AirPod stem slides into. The buds hang nose-up, the way they sit in the case, so you pick them up the right way round without looking. One piece. No glue, no magnets, no hardware. Fits
- AirPods 1 and AirPods 2 — the stemmed ones
- Not for AirPods 3, Pro or Max: different stem and body
- Size — 72 × 40 × 59.5 mm
- Base — round, 11.3 cm² of contact; it does not tip when you take one out
Printing
- 0.2 mm layers · 3 walls · 15% gyroid · 5 top / 4 bottom · PLA
- Supports on. Measured on the mesh: 452 mm² of flat ceiling sits in mid air at z = 52.5 mm — the underside of the two collars. Tree supports, threshold 30°, and not build-plate-only, since part of it grows off the stem. Everything below that height is self-supporting.
- No brim. The base holds on its own.
- Small part: it fits any plate from the A1 mini upward.
Print it in one colour — the ring lines on the base and the stem are the wall paths, and they read as grain on a stalk. More from FAMER
Descripción original del autor, publicada en MakerWorld.
