AA and AAA battery dispenser for Ikea Skadis
por SubSite en Printables
A print-in-place dual dispenser with a recycle bin. Print with supports or use the built-in support version.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a SubSite.
Archivos (4)
- Categoría
- Organización
- Formatos
- 3MF
- Descargas
- 518
- Publicado
Sobre este modelo
A print-in-place AA and AAA holder, including a separate recycle bin. This is a pretty demanding print. Some tips: - Use supports for the upper hooks, or print the version with built-in support.
- Make sure you have good bridging!
- After printing, take a good look inside and use an X-Acto knife or similar to remove any filament from failed bridging. The dispenser will not work if there is even a single strand of filament left hanging somewhere.
- I recommend you use lots of perimeters for the hooks.
Descripción original del autor, publicada en Printables.
