911/964 Cam position sensor #2
por Jeremy Moore en Thingiverse
In this updated sensor boss, I have moved the point of pickup of the sensor further away from the center of the cam shaft to improve the accuracy of the signal in degrees. If you use an M6 bolt as the trigger pin, you should see an improvement in accuracy from 1/6 of the rotation to 1/9th or 1/10th.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Jeremy Moore.
Archivos (1)
- Categoría
- Repuestos
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
In this updated sensor boss, I have moved the point of pickup of the sensor further away from the center of the cam shaft to improve the accuracy of the signal in degrees. If you use an M6 bolt as the trigger pin, you should see an improvement in accuracy from 1/6 of the rotation to 1/9th or 1/10th of the rotation.
Descripción original del autor, publicada en Thingiverse.
