90 Degree Corner Clamp - holds two boards square for gluing and screwing (100% printed)
por DELLOO2008 en Printables
Clamps two boards at a perfect 90 degrees with two separate screws, so your hands are free to glue or screw.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a DELLOO2008.
- Categoría
- Herramientas
- Formatos
- 3MF, STEP
- Descargas
- 53
- Publicado
Sobre este modelo
Put one board against each fence and turn the knobs. Each screw drives its own pressure pad, so you can clamp two boards of different thickness. The fences are one solid printed part, so the corner is always 90 degrees. - Clamps boards from 3 to 24 mm thick on each side
- Two independent screws with a big knob for good hand force
- The pads ride in a guide slot so they stay straight and clip onto the screw tip, so they pull back when you loosen
- Relief hole in the corner keeps glue squeeze-out away from the joint
- Printed nuts drop into slots in the posts, no metal hardware needed
- Three countersunk holes to screw it to your workbench (optional)
Not tested yet - designed and checked in CAD (all threads and parts checked for fit and clearance over the full clamping range).
Descripción original del autor, publicada en Printables.
