4.8L Small Form Factor PC Case - Console Style

This is a fully printed custom PC case that is 4.8L, and can be printed on an A1 (256mm x 256m x 256mm).

Todos los archivos (10) en un ZIP

Licencia

Solo uso personal

Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.

Al descargar aceptas respetar la licencia y dar crédito a HobbyBoi.

Archivos (10)

It is designed to fit the following parts: - Motherboard: ASRock B650I Lightning Wifi Mini-ITX

- Cooler: Thermalright AXP90-x36

- GPU: ASUS Pheonix GeForce RTX 3060 12GB

- PSU: Apevia 500W Flex-ATX

Hardware needed: - M3 Heat-Set Inserts: https://www.amazon.ca/dp/B0CS6VZYL8?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1

- M3 Screws: https://www.amazon.ca/dp/B0FP4CGQ9J?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1

- PSU Extension cable: https://www.aliexpress.com/item/1005007295578022.html?spm=a2g0o.order_list.order_list_main.14.10151802uiKtCp

- GPU Riser Card: https://www.aliexpress.com/item/1005006057004647.html?spm=a2g0o.order_list.order_list_main.29.10151802uiKtCp

- 90 Degree GPU power cable: https://www.aliexpress.com/item/1005009328003501.html?spm=a2g0o.order_list.order_list_main.19.10151802uiKtCp

- Push Button: https://www.amazon.ca/dp/B07F9PF8MP?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1

Additional Notes: - Printed on a BambuLab A1

- PLA risks warping under high heat. Use high-temp filaments

- Longer GPUs could technically fit within the case's volume, but some support geometry would need to change.

Once Assembled, the case looks like this:

Modifications Needed: - Remove the following parts of the motherboard I/O shroud (I used a grinder):

- Remove the GPU's fan shroud, and front plate.

- Remove this edge of the GPU's backplate:

- Will likely need to make a shorter 24pin power cable. The stock one that comes with the Apevia PSU is much too long:

Descripción original del autor, publicada en Printables.