3D printed tool hanger
por Igor Albuquerque en MyMiniFactory
Designed this modular tool holder to keep my tools (screewdrivers, hex drivers, calipers, pliers, hammer, etc.) organized on my desk.
Licencia
Solo uso personalMyMiniFactory - Credit - Remix - Noncommercial
Licencia de MyMiniFactory: puedes imprimirlo y remezclarlo dando crédito, sin fines comerciales.
Al descargar aceptas respetar la licencia y dar crédito a Igor Albuquerque.
Archivos (9)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 1,692
- Publicado
Sobre este modelo
Designed this modular tool holder to keep my tools (screewdrivers, hex drivers, calipers, pliers, hammer, etc.) organized on my desk.
It was designed to be installed on my office, in a 25 mm gap between two wood pannels, without fasteners. I added a backside hole later, so that the modules might also be wall mounted using some screws (actually I didn't test this method).
Instructions on how it was designed at https://www.instructables.com/id/3D-Printed-Tool-Hanger/
Did you know you can buy the Anet A8 for only $129.99? Use the coupon code A8KIDA at Gearbest and get it! http://bit.ly/2kqVOdO
Descripción original del autor, publicada en MyMiniFactory.
