3-in-1 Safety Razor Holder, Blade Disposal, and Refill Box Dispenser Station

Hello! I have made this 3-in-1 Dorco-PL602 razor station (though it should work with any razor with handle diameter roughly 11.8mm / 0.5 in! and can be changed by editing the STEP file). Print without internal supports (the box should be hollow) and with external supports on the overhangs.

The left side of the model is hollow, and included is a slot to place the used blades in. The right side of the model holds the "standard" razor refill box size of 28 x 50 mm^2, and the boxes can be slid out from the bottom. Pictured on my kitchen sink is V0.9, though I have moved the slit slightly for V1.0. Also included is a little drain hole, so that the razor holder does not get nasty from standing water. The bridging to the right of the razor mount is a bit gnarly, but my printer can handle it!

I was very frustrated by my disorganization pertaining to the baggies of razor blades in miscellaneous boxes around my bathroom sink. And I was disturbed by my past decision to make surprise danger boxes/drawers with used blades. This fixes all of these problems.

Hope this is of use.