3-Ball Wool Dryer Ball Stand with Airflow Holes
por Filthy Clean en MyMiniFactory
Check your balls fit before you print. Grab a ruler and measure across the middle of one dryer ball. This stand is made for 75 mm balls and its cradles take anything up to 76 mm. Smaller balls sit lower and still work. Bigger ones will perch on top.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Filthy Clean.
- Categoría
- Hogar
- Formatos
- 3MF, STL
- Descargas
- 1
- Publicado
Sobre este modelo
Check your balls fit before you print. Grab a ruler and measure across the middle of one dryer ball. This stand is made for 75 mm balls and its cradles take anything up to 76 mm. Smaller balls sit lower and still work. Bigger ones will perch on top.
Each cradle is a spherical pocket 22 mm deep, with an airflow hole through the floor. The base is flat and the corners are rounded, so it sits steady on a shelf or the top of a dryer.
It was made to suit Aussie-owned wool dryer balls from Filthy Clean: New Zealand wool, 75 mm across.
Printing it One part. PETG recommended, PLA away from heat. 0.2 mm layers, 3 walls, 15% infill. No supports. Footprint 247 x 87 mm, 26 mm tall. Your bed needs 250 mm in one direction.
First release, untested. A make would help other people.
Designed by Filthy Clean. Creative Commons Attribution 4.0. Brand name not licensed.
Descripción original del autor, publicada en MyMiniFactory.
