270 Degree Hinge for Elegoo Centauri Carbon
por MagicShrimp en Printables
Replaces the stock hinges with hinges that allow the door to be opened completely.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a MagicShrimp.
Archivos (14)
- hinge_upper.stl STL · 226 KB
- hinge_lower.stl STL · 229 KB
- arm_upper.stl STL · 267 KB
- arm_lower.stl STL · 279 KB
- nut_block.stl STL · 46 KB
- plastic_spacer.stl STL · 89 KB
- hinge_upper.stp STP · 81 KB
- hinge_lower.stp STP · 81 KB
- arm_upper.stp STP · 62 KB
- arm_lower.stp STP · 64 KB
- nut_block.stp STP · 36 KB
- plastic_spacer.stp STP · 9 KB
- nut_block_slim.stl STL · 57 KB
- 270 Hinge Instructions.pdf PDF · 37 KB
- Categoría
- Para tu impresora
- Formatos
- STL, STP, PDF
- Descargas
- 9,695
- Publicado
Sobre este modelo
Required Stls: - 1x hinge_upper - 1x hinge_lower - 1x arm_upper - 1x arm_lower - 2x nut_block - *4x plastic_spacer
*The plastic spacers go in the glass cutouts to align the panel and prevent the metal screw from touching the glass.
Required Hardware: - 4x m3 8mm Socket Cap Screws (for side panel) - 4x m3 12mm Socket Cap Screws (for glass panel) - 2x m3 30mm Socket Cap Screws (for hinges) - 6x m3 Nuts - 4x m3 washers thickness between .5mm and .7mm (for arms) - 4x washers from existing hinge
Installation instructions can be found in the files section if you need them. It seems newer batches of the CC have the hinges glued to the door. If yours are glued you will need to unscrew the original hinges before you can remove the door.
Notes: Print the plastic spacers with wall print order outer to inner, the rest can be printed inner to outer for better overhangs. .2 layer height Some addons for the hinge can be found here: https://www.printables.com/model/1213120-extras-for-270-degree-hinge
Descripción original del autor, publicada en Printables.
